Creating a new controller.ini for your controllerYou need my tool called HIDTest to determinate the values.
Most entries should be obvious.
All values are in hex, do not use the 0x prefix.
Polltype:
Use 1 (so far only the PS3 controller needed 0)
DPAD:
Certain pads use bits for each DPad direction other use numbers going
form 0 to 7 for each direction.
An easy test for this is if one direction doesn't change any bits then
use 1 and fill in all 8 values for the DPAD otherwise use 0 and just fill
in the four values. (see examples)
DigitalLR:
If your pad doesn't have analog triggers for L and R, set this to 1.
It will consider the trigger buttons as fully pressed when you use L or R.
MultiIn:
Certain USB adapters have multiple inputs here you can select
which port data to use.
First set MultiIn=1 and then set MultiInValue to either 0,1,2,..
it depends on the adapter and the port you are using.
The rest uses [Button]=[offset],[mask] offset starts at 0.
http://github.com/FIX94/Nintendont/raw/master/controllerconfigs/HID_Test.dolhttp://github.com/FIX94/Nintendont/tree/master/controllerconfigs 
